Sieraden maken

Dit zijn prachtige steenkralen, lava kralen en een metalen kraal met een spiraal geregen op elastiek.

1

Put the beads on elastic beading cord in the desired order. Finish with a series of knots. Tighten hard after each knot.

Echte leren sieraden

Knip/Snij echte leren bloemen, pons met een eyelet en bevestig aan een leren koord.

1

Draw the flowers using the shape template – cut out.

2

Punch holes and insert eyelets.

3

Punch the two flowers together.

4

Cut two pieces of leather cord each measuring 110cm and one piece of leather cord measuring 130cm.

5

Til knuderne klippes 3 stykker lædersnøre á 25 cm.

6

Double over the 25cm long cord and put on the six doubled over cords.

7

8

9

10

11

12

Tie a total of three knots – one knot on each side tied around three cords and the third knot gathering all six cords below.

13

Pull a flower onto the end of the longest cord.

14

Tie a knot. Twist three times around your finger, pass the cord end through the loop and tighten.

15

Pass the cord end through the flower.

16

Pass the cord end up through the other flower.

17

Tie another knot.

18

Pass the cord end down through the flower and tie on the reverse.

19

Attach beads onto the cord ends and glue on end caps.

20

Prachtige oorbellen

Decoreer een ornamentale hanger met champagne gouden ketting en koperen glaskralen en bevestig aan een Franse oorbelhaak.

1

This is how you make a small bead pendant: Put a glass bead onto a head pin and bend it slightly towards you as shown in the photo.

2

Twist the pin around the round nose pliers as shown in the photo.

3

Twist a total of three rounds and cut off the excess pin with a pair of side cutters.

4

Cut a single link of the chain and attach it to the small bead pendant.

5

Attach the small bead pendant onto a round jump ring with an ornament pendant in a French ear wire.

6

Twist the ear wire a quarter of a round by holding it in place with the pliers as shown on the photo whilst holding onto the ear wire with your fingers and rotate 90 degrees clockwise.

7

Cut three short pieces of the chain. We have four links on two of the pieces and five links on the third piece of chain.

8

Make three small bead pendants as described in steps 1-3.

9

Open up the outer link on the small chain, attach the bead pendant and close the link again.

10

Open up the link in the other end of the chain pendant, put it onto the ornamental pendant as shown in the photo and close the link.

Sieraden maken

Een prachtige haarband gedecoreerd met een organza bloem.

1

Cut some long thin strips of organza to cover the hair band. Also, cut out four or five flowers.

2

Twist the long strips around the hair band. Attach the organza with the glue gun.

3

Stagger the cut out flowers and sew them together in the middle. Decorate with sewn on beads.

4

Glue the flower onto the hair band with the glue gun.

5

Finally heat with a heat gun. The organza will shrink so be careful and only do a small area at a time. Heat all the way around the flower.

Oorbellen

Bevestig zomer en zonneschijn in je oren! Super simpele oorbellen met hangers gemaakt van rondellen, kokosnootkralen en glaskralen met bloem.

1

Attach a flower glass bead, a rondelle spacer bead and a coconut bead onto a ball head pin. Grip the pin with round nose pliers and turn the pin towards you.

2

Turn the pin around the round nose pliers.

3

Twist the pin around itself as shown in the photo.

4

Cut off the excess pin with side cutters.

5

Open the French earwire.

6

Attach the pendant and close the French earwire again.

7

The earring is now ready to be used.

Memory wire armband

Rijg verschillende maten kralen op het memory draad. Decoreer met hangers op een paar plaatsen en aan elk uiteinde.

1

Cut three rounds of memory wire.

2

Make a loop in one end with round nose pliers.

3

Thread beads on in the desired order.

4

Finish off by making another loop.

5

Make pendants like this: Put a head pin through a bead and bend the pin towards you.

6

Turn the pin around the pliers as shown.

7

Turn the pin around three times as shown and cut off the excess.

8

Attach a round jump ring to the pendant and attach it onto the loop at the bracelet.

9

If you wish, you can attach more pendants by attaching a round jump ring onto the memory wire itself and then attach a pendant to the round jump ring.

Prachtige sieraad voor bruine enkels

Een leren koord met schuifsluiting, gedecoreerd met rondellen, kokosnoot kralen en een glaskraal met bloem.

1

Attach a flower glass bead and a rondelle spacer bead onto a ball head pin and bend the pin as shown.

2

Turn the pin and attach the spacer bead.

3

Twist the pin as shown.

4

Twist around a few more times and cut off the excess pin.

5

Cut a piece of leather cord. It should measure 2 x the circumference of your ankle, plus 15cm. Thread coconut beads, rondelle spacer beads and the pendant on.

6

Arrange the cord as shown on the photo.

7

To make an adjustable knot you start as follows:

8

Twist the cord three times around the cord.

9

Put the cord through the coils and tighten carefully. Each twist must lie close to the other cord.

10

Like that.

11

Cut off the excess ends.