Geschreven: 23 februari 2017 door admin
Gedecoreerde kerstboom voor aan de muur
Een simpele kerstboom voor aan de muur is gedecoreerd met Vivi Gade Design vilt en pom-pom lint.
1.
Cut a width of Vivi Gade Design felt equivalent to the width of the Christmas tree wall hanging x 15cm.
2.
Attach the felt border with pins.
3.
Sew it on with ordinary tacking stitches.
4.
Sew on the pom-pom ribbon using the same procedure. You may sew on the felt border and the ribbon at the same time.
Geschreven: 23 februari 2017 door admin
Kaart met Masking Tape
Deze kaart is gedecoreerd met masking tape. Kleine stukken dubbele masking tape zijn geknipt als vlaggen en bevestigd op een stuk katoenkoord.
Geschreven: 23 februari 2017 door admin
Hart voor de kerstboom
Ons prachtige Vivi Gade papier is gemaakt in vier verschillende series, Helsinki, Oslo, Copenhagen en Stockholm. Geef je Kerstmis de kleur die je wil of mix de verschillende series.
Koop een kit om circa 45 harten te maken of koop de artikelen individueel.
Klik hier om het sjabloon en de instructies te bekijken in een printvriendelijke versie:
www.masterpiece.dk/UploadetFiles/10…
1
Fold the paper and cut-out the pattern – repeat with another piece of paper.
2
Push one end from the left side into the right half.
3
Weave the other strips alternately through and over each other.
5
Finally insert the last paper end into the last paper slot from the other half of the heart.
6
Cut a paper strip for the handle and attach it onto either side of the inside heart with double-sided adhesive tape.
7
Cut off the legs of a brad.
8
Glue the brad onto the heart using a glue gun.
Geschreven: 23 februari 2017 door admin
Goede keuze
Ons Vivi Gade Design papierblok met papier en karton van Vivi Gade Design biedt een enorme hoeveelheid mogelijkheden voor het maken van prachtige decoraties en kaarten in bij elkaar passende kleuren en stijlen. Het papierblok bevat ook sjablonen/knippatronen.
The Paperbook contains 40 sheets of paper and 10 sheets of card. All the ideas below are made using paper from one single Design Paperbook. This still leaves quite a few sheets. You may want to blacken the edges to achieve an old look. You can make small, fine dots using a Paper Pen. Enjoy.
The cutting pattern of the classic woven hearts is available in two variants in the Paperbook. See idea No. 1335 for instructions of how to weave a heart.
Make a double cone by following the instructions in idea No. 11264.
The Vivi Gade folding box is made following the instructions in idea No. 1340.
Lovely to and from cards.
The decorations are assembled in pairs around a ribbon for hanging.
The folded envelope cards are folded from a single piece of paper. These are made by following the instruction in idea No. 11418.
The cards become extra special when decorated with ribbon.
The cutting pattern for these lovely cones is included in the Paperbook.
The parts for the figures on these cards are cut following the templates in the Paperbook.
Using the woven hearts looks really attractive when decorating the cards.
Geschreven: 23 februari 2017 door admin
Kerstdecoraties
Schattige kaboutermeisjes gemaakt van vilt en volgens een eenvoudig sjabloon. Het haar is gemaakt van Barcelona garen dat op het stoffen hoofd is gelijmd.
1
Cut out according to the template.
2
Sew the hat together with buttonhole stitches.
3
Sew the edges with buttonhole stitches.
4
Sew the body together with buttonhole stitches.
5
Fill the body 1/3 with plastic pellets.
6
Fill with polyester stuffing.
8
Cut 2m yarn for hair. Fold the yarn four times and tie it in the middle.
10
Cut the hair to a desired length.
11
Cut the scarf from knitted tube – 25cm. Dress the pixie in hat and scarf.
Geschreven: 23 februari 2017 door admin
Paper Decorations
Here eight square pieces of paper are folded and assembled to make lovely decorations. The paper as well as the ribbon is from the Vivi Gade Design Stockholm series.
Follow the folding instructions below. Use a bone folder to make sharp folds. Using the Vivi Gade Design paper, the decoration acquires a lovely firmness but it may be a little difficult to fold for the beginner. If so you may wish to use our origami paper which is a little thinner and therefore easier to work with.
1
Cut eight pieces of paper measuring 8x8cm.
3
Unfold and fold each side towards the fold in the middle.
4
Fold in half and turn the fold down towards yourself.
6
Unfold and fold both corners down towards the bottom fold.
7
Fold in half and press thoroughly using a bone folder. Fold the remaining seven pieces of paper in the same way.
8
Assemble the decoration by inserting the tips as shown in the photo.
9
The decoration achieves its proper shape by pushing the sides towards the middle.
10
Decorate with a ribbon for hanging and a bow. You may attach small rhinestones.
Geschreven: 23 februari 2017 door admin
Hangende kerstdecoraties
Deze winterse glazen kerstballen zijn gedecoreerd met decoupagepapier en 3D sneeuw pasta.
1.
Knip een motief uit decoupagepapier.
2.
Lijm het motief op de glazen kerstbal met decoupagelijmlak. De kant met de afbeelding wordt tegen de bal gelijmd.
3.
Breng 3D sneeuw pasta aan op de achterkant van de kerstbal en lanngs de rand aan de voorkant.
Geschreven: 23 februari 2017 door admin
1
Cut out after the pattern.
2
Sew the hat with botton hole stitches.
3
Sew the edges with boton hole stitches.
5
Fill the body 1/3 with plastic pellets.
6
Fill the rest of the body with doll stuffings.
8
Cut 2 m yarn for hair. Fold the yarn 4 times and tie at the middle.
10
Cut the hair in the wanted length.
11
Cut the scarf from knitted tube- 25 cm. The elve is dressed in hat and scarf.
Geschreven: 23 februari 2017 door admin
Glass Dish
Decorated on the reverse with die-cut daisy motifs made from Vivi Gade Design Helsinki Paper and dabbed with Plus Color Craft Paint.
Geschreven: 23 februari 2017 door admin
Een gewoven ster
Een Chinese ster gevouwen van papieren vlechtstroken.
1.
Tie a knot at one end of the weaving paper strip.
2.
Gently tighten the knot and flatten it. This is now an equilateral pentagon.
3.
Tightly wrap the long end of the strip around the pentagon, whilst following the edge.
4.
Tuck the small end of the strip underneath to hide it.
5.
Continue wrapping the strip around the star until the right thickness is reached. Do not make it too thin. Make it thick enough for it to slightly resisting to be pressed firmly, when pushing/pressing the star into shape. The smaller the star, the shorter the strip. You may use the entire strip for the largest star.
6.
Cut off the strip close to the edge of the star.
7.
Fold the end of the strip underneath the folds to hide it.
8.
Push in all five sides using your thumb.
9.
When making the big star, it may be necessary to glue two of the edges in place.
10.
Use a needle to push a hole in the star for the piece of string for hanging.ål prikkes hul til ophængssnor.