Archief | Hobby evenementen

11189 Ketting met peace teken

Geschreven: 24 februari 2017 door admin

Kleurrijke sieraden

Een ketting gemaakt van 3 rijen glaskralen. De hanger is gemaakt van oranje en donkerrode fashion mix kralen, vier rocaille kralen en koperdraad.

1

Make three rows of beads on beading wire. Length = 75cm.

2

Assemble the three ends in a bead tip with a loop and attach a crimp bead. Squeeze the crimp bead flat.

3

Close the bead tip.

4

Attach an oval ring and a clasp.

5

Attach an oval ring at the other end of the necklace.

6

Cut a piece of brass wire measuring approx. 40cm. Pull 18 dark red Fashion mix beads onto the wire. Pass both wire ends through the same bead at the end.

7

Twist the two ends around the bead as shown in the photo to lock. You can twist it many times, so that the brass wire resembles a bead.

8

Assemble both ends in the middle of the circle.

9

Put five orange Fashion mix beads onto the wire and arrange the ends as shown in the photo.

10

Twist the ends around the bead as shown in the photo. Make “beads” as shown in step 7.

11

Cut off the excess ends.

12

Cut a new piece of brass wire measuring approx. 30cm and secure one end as shown in the photo by twisting it between two beads.

13

First attach a rocaille bead onto the wire, then two orange Fashion mix beads and finally a rocaille bead.

14

Twist again, as shown in the photo.

15

Repeat step 13 by twisting and cutting off the excess wire.

16

Cut a piece of brass wire measuring approx. 60cm and twist it around a mandrel.

17

Twist the entire wire.

18

Cut a piece of brass wire approx. 10cm longer than the spiral and put it inside.

19

Bend and place the ends as shown in the photo.

20

Twist the ends around the upper bead. Cut off the excess.

21

Hold the pendant with one hand and hold the spiral with the other hand. Twist gently.

22

Put the necklace through the spiral and the necklace is ready for use.

Reacties uitgeschakeld voor 11189 Ketting met peace teken

11441 Ketting met rocailles

Geschreven: 24 februari 2017 door admin

Sieraden

Simpele en prachtige ketting met rocailles en een grote verzilverde kraal.

1

Cut a piece of beading wire and thread this in a beading needle. The needle is easy to pull through the bead as it is hollow.

2

Pull rocaille beads onto the wire to a length that can go over your head.

3

Close the necklace as shown with crimp beads. Pull both wire ends and squeeze the crimp beads flat using flat nose pliers.

Reacties uitgeschakeld voor 11441 Ketting met rocailles

11375 Armband met een leren koord

Geschreven: 24 februari 2017 door admin

Sieraden

Een simpele armband gemaakt van een vlecht van vier strengen van natuurlijk gekleurd leer en met een enkele metalen bloem.

1

Cut two pieces of 2mm thick cord each measuring approx. 80cm. Double over both of them simultaneously and tie a loop.

2

Attach the cord at the loop end and plait with four cords. See the pictures.

3

4

5

6

Pull the flower link onto the two middle cords. Continue plaiting.

7

Assemble the cords in a knot.

8

Attach small metal discs on each of the four ends and tie a knot on each end.

Reacties uitgeschakeld voor 11375 Armband met een leren koord

11254 Leren armband met bedels

Geschreven: 24 februari 2017 door admin

Sieraden maken

Een vrouwelijke armband van metallic leren koord met liefelijke bedels en hangers.

1

Put a bead onto a head pin. Trim the head pin so you have 12mm to make a loop.

2

Use round nose pliers to make a loop.

3

Bend back.

4

Close around the ring.

5

Cut four pieces of leather cord, each measuring approx. 55-60mm. Glue on an end cap.

6

Attach pendants, charms and rings. Close with an end cap at the other end.

7

Attach a clasp with a round jump ring and distribute the pendants around the bracelet.

 

Reacties uitgeschakeld voor 11254 Leren armband met bedels

11376 Ethnische armband

Geschreven: 24 februari 2017 door admin

Sieraden

Een etnische armband met keramieke kralen en gevlochten met natuurlijk gekleurd leren koord.

1

Pull the beads onto a piece of 2mm thick leather cord measuring approx. 55cm. With a new piece of leather cord, braid a distance on each side of the beads.

2

Fasten the ends on the back.

3

Arrange the two original ends parallel and braid a short distance with a new piece of cord so the length fits. Fasten as before.

4

Close the two original ends with metal discs and a knot. Now you can vary the length.

Reacties uitgeschakeld voor 11376 Ethnische armband

1438 Ketting met filigrain

Geschreven: 24 februari 2017 door admin

U kunt simpele en elegante sieraden maken in elk gedroomd ontwerp

Necklace:

1

Attach a wax bead, a giga heart, a filigree, a careye bead and a rondelle with rhinestones on a head pin.

2

Bend the pin 90 degrees.

3

Twist the stalk around the round nose plier and bend down the end.

4

Cut off approx 40 cm jewellery chain and mount a cord end.

5

Squeeze.

6

Mount an Oval ring in the cord end.

7

Attach a lobster claw clasp and close the oval ring. Attach the angel jewellery and mount an oval ring in the other end.

Earrings:

1

Put a cateye bead and a filigree on a head pin. Twist the stalk 90 degrees.

2

Twist the stalk around a round nose pliers.

3

Twist it around a couple of times.

4

Cut off the excess stalk.

5

Open the eye of the earhook.

6

Mount the cateye bead and close it.

Reacties uitgeschakeld voor 1438 Ketting met filigrain

11385 Armband met knopen

Geschreven: 24 februari 2017 door admin

Sieraden

Een prachtige en eenvoudige armband gemaakt van knopen en gewaxed katoenkoord helemaal passend bij de huidige trend.

1

Cut two pieces of waxed cotton cord each measuring 40cm and attach coconut buttons and pony glass beads as shown.

2

Arrange the ends of the cord so they are parallel and join them with a new cord and braid as shown.

3

Fasten the braiding cords on the back and trim.

4

Decorate the four cords with beads and close with two knots.

Reacties uitgeschakeld voor 11385 Armband met knopen

11389 Suede armband

Geschreven: 24 februari 2017 door admin

Sieraden

Een armband gevlochten van suède koord met kokosnoot kralen als decoratie en als slot.

1

Cut two pieces of suede cord; one measuring 70cm and one measuring 35cm. Double over the long piece of cord and glue one end of the short cord around the loop.

2

Plait the three cords, keeping them flat.

3

Close in the same way as in the beginning. Cut off the two outer cords.

4

At the end of the plaited bracelet glue or sew on a button for fastening with the loop.

5

Sew on a large button in the middle of the bracelet as decoration.

Reacties uitgeschakeld voor 11389 Suede armband

11800 Romantische ketting met hanger

Geschreven: 24 februari 2017 door admin

Ketting met kant

Een bewerkt medaillon in de vorm van een hart, bevestigd aan een ketting gemaakt van jasseron en kanten lint. De sleutel en de bedel in de vorm van een blad zijn aan het hart bevestigd met ronde ringen.

1

Cut two pieces of chain to your chosen length. Assemble the chains in both ends with a round jump ring and then pull on the heart.

2

Now attach the chains with another round jump ring.

3

Cut two pieces of lace border approx. 20cm longer than the chains. Pull the lace border through the heart and the two outer round jump rings when assembling the chains.

4

Adjust the lace borders so that the length fits with the chains. Tie a knot.

5

Assemble the pendants with a round jump ring.

6

Attach the pendants to the heart with another round jump ring.

Reacties uitgeschakeld voor 11800 Romantische ketting met hanger

11333 Sieradenset gemaakt van dik leer

Geschreven: 24 februari 2017 door admin

Sieraden

Een sieradenset gemaakt van dik leren koord met metalen links en een dun koord met lava kralen aan elkaar gevlochten.

1

Cut two pieces of thick leather cord, measuring the length around the neck. One must be slightly longer than the other. Glue one end into an end cap together with a long thin cord.

2

Thread links onto both cords – before they gluing them into an end cap. Note the thin cord must not be glued into the end cap with the other two cords!

3

Thread lava beads onto the thin cord. Twist the cord around the thick leather cords, alternating with a lava bead in-between. Remember to distribute the metal links in-between.

4

When the chain is full, cut the thin cord and glue it into the end cap.

5

Attach oval jump rings and a clasp.

6

The bracelet is made in the same way; only the two thick leather cords must be of equal length.

Reacties uitgeschakeld voor 11333 Sieradenset gemaakt van dik leer