Geschreven: 14 januari 2017 door admin
Armbanden met krimpfolie
De armbanden zijn gemaakt van schoenveters. De hangers en de verstelbare knopen zijn gemaakt van krimpfolie vellen en plastic kralen.
1.
Draw and decorate on a shrink plastic sheet using Colortime Coloured Pencils. Use the template.
2.
Cut out and make holes with a hole puncher. The adjustable buttons must have two elongated holes size 1 x 2cm. See the template.
3.
Shrink the shrink plastic sheets in a warm household oven at 130 degrees to approx. 1/3 size.
4.
Cut a shoelace in two and wrap sticky tape around the ends.
5.
Push the ends through the adjustable buttons or plastic beads and attach the pendant with an oval jump ring.
6.
Before and after the shrinking.
Geschreven: 14 januari 2017 door admin
Hippe armbanden
Gevlochten van een schoenveter. Een knoop is meegevlochten als sluiting.
1
Double over the shoe lace and tie a loop.
2
Pull a link button onto both ends and place it where you want the bracelet to finish.
3
Braid around the two shoe laces with the ends and make sure to keep the ends flat.
4
When the ends are used up, tie knots to lock the ends. One on each side.
Geschreven: 14 januari 2017 door admin
Armbanden
Sieraden gemaakt op memory wire. Kralen zijn op het draad geregen dat aan beide kanten is afgewerkt met eindkappen die erop zijn gelijmd.
1.
Close off one end of the wire by glueing a memory wire end cap in place using Super Attak brush-on instant glue.
2.
Thread the beads onto the memory wire. Be careful not the pull the wire out of shape.
3.
When the entire wire is filled with beads, lock it by glueing on another memory wire end cap.
Geschreven: 14 januari 2017 door admin
Indiaanse sieraden
Vrouwelijke en kleurrijke sieraden. Indiaanse kralen en rozen van klei zijn geregen op een stuk elastiek.
1.
Thread beads and clay roses onto a piece of elastic beading cord and finish with two reef knots.
Geschreven: 14 januari 2017 door admin
Schoenveters als sleutelkoord
Een trendy sleutelkoord gemaakt van schoenveters.
1
Pull the swivel clasp onto the shoe lace.
2
Place the shoe lace ends over each other and place the second shoe lace across.
3
Braid the shoe lace and stop approx. 5cm before the swivel clasp.
4
Turn the key hanger over and twist one end of the shoe lace around the braiding.
5
Push the ends underneath and pull.
Geschreven: 14 januari 2017 door admin
Trendy armband gemaakt van leer met haaksluiting
Wikkel het stuk leer twee maal om de pols en knip op de juiste lengte. De sluiting is gelijmd met Super Attak Instant lijm. Eén eindkap is verschuifbaar.
1
Cut a piece of leather measuring approx. 42 x 46cm.
Attach the end cap.
2
Attach the end cap.
Drip a small amount of Super Attak Instant Glue in the fastener and attach the ends.
Geschreven: 14 januari 2017 door admin
Indiaanse sieraden
Dit is een vrouwelijke, Indiaanse ketting met veren en Indiaanse kralen op een leerkoord.
1.
Glue the guinea fowl feather into an end cap.
2.
Attach a round jump ring to the loop of the end cap.
3.
Cut a piece of leather cord measuring 150cm and thread the pendants onto the cord. The cord is now doubled over. Cut a 60cm long piece of leather cord and braid around the doubled over piece of cord. See the technique described in our Jewellery School.
4.
Half-way through the braiding, thread a bead onto the two middle cords (the doubled over piece of cord).
5.
Now secure the ends from the braiding using a darning needle.
6.
Approx. 12cm from the braiding, tie a single knot on each of the two cords and thread beads onto each cord. The holes of the beads vary in size.
7.
Trim the leather cords. Put some glue inside the bead and insert the ends of each piece of cord into the bead.
Geschreven: 14 januari 2017 door admin
Handtas hangers
Hangers gemaakt van kleine stoffen figuren, sieradendraad, gevuld met rocailles, een ringetje en een slotje.
1.
Cut off the string from the mini fabric animal and pull the wire through (you may need a needle).
2.
Close at the bottom with a crimp bead.
3.
Thread rocaille beads and a rhinestone rondelle onto the wire at the top.
4.
Attach a lobster claw clasp by closing with a crimp bead.
Geschreven: 14 januari 2017 door admin
Trendy armband
De prachtige magnetische sluiting is gelijmd op 4 stukken 2mm leerkoord met Super Attak Instant lijm.
1
Cut four pieces of 2mm leather cord at a suitable length for the wrist (approx. 14cm). Measure your wrist and remember to deduct the length of the clasp.
2
Glue the ends of the leather cord inside the clasp using Super Attak Instant Glue.
Geschreven: 14 januari 2017 door admin
Armbanden
Lava kralen en Fashion Links geregen op een elastisch koord geknoopt met platte knopen.
Thread your chosen lava beads and antique silver beads onto a piece of 1mm elastic cord. Tie five to six tight knots. When tightening the elastic cord, it locks itself. The knot is a reef knot, i.e. the cord which is towards the body is put over the other cord and then tied. Then it is repeated with the other cord and so on alternately.