Sieraden maken

Een prachtige ketting met een parelmoer glans. Rijg kleine kralen en oyster kralen op sieradendraad. Werk af met een ronde jumpring en een slot.

Ear rings

A shell bead and a small bead put onto a ball head pin and attached onto a French ear wire.

Armband van zoetwater parels

1

Thread beads onto a piece of beading wire. Finish bracelet with a bead tip and a crimp bead in one of the ends.

2

Finish the other end in the same way – but please remember – before squeezing the crimp bead the wire must be in the ring.

3

Attach a round jump ring with a message charm to one of the ends and a round jump ring with clasp in the other end.

Ketting met hanger

Kleine kralen van steen geregen op sieradendraad. De hanger is bevestigd met een ovale ring. Gesloten met knijpkralen.

1

Thread genuine stone beads and silver beads onto a piece of beading wire.

2

Attach an oval jump ring onto the pendant. If the loop of the pendant is turned across, attach another oval jump ring to ensure that the pendant hangs straight.

3

Thread the pendant onto the necklace.

4

Close the necklace by attaching two crimp beads with a bead in between. Feed the wire ends through from either side. Pull the ends and squeeze the crimp beads flat using pointy chain nose pliers.

Rustieke armbanden

Armband gevlochten van Design koord en sluiting gemaakt van een gesp sluiting.

1.

Glue two pieces of design cord – each measuring approx. 25cm – into one part of the hook clasp.

2.

Double over approx. 2 meters of cord and tie it onto the two cords.

3.

Now braid till you have reached the desired length.

4.

Cut off the braided ends and glue them in place on the back.

5.

Cut off the ends and glue these in the other part of the hook claps. Remember to check that it is turned the right way in comparison to the first one.

Ketting met organza

Kleine kralen van steen geregen op sieradendraad. De organza decoraties zijn bevestigd aan een metalen kegel als een hanger. Gedecoreerd met facet kralen op een nietstift.

1.

Cut as much away from the felt base of the carnation as possible.

2.

Push a head pin through the flower.

3.

Put the metal cone onto the head pin, and nip off 5-7mm of the pin. Twist the rest to make a triple eye using the middle of the round nose pliers. Keep twisting until the cone is pushed completely down and covers the felt base of the flower.

4.

Cut a piece of beading wire measuring approx. 1m and thread small genuine stones onto the wire. Start in the bottom middle with 10-12 stones. Attach a wide oval metal ring before threading the rest of the stones onto the wire.

5.

Close the necklace with crimp beads. Pull the ends and squeeze the crimp beads flat.

6.

Attach the necklace and the pendant using an oval jump ring.

7.

Put faceted beads onto head pins, nip off some of the pin, leaving 1cm. Twist to make a loop which is then attached onto the oval jump ring on the necklace.