Geschreven: 23 februari 2017 door admin
Handgemaakte kleikralen
Keramieke kralen en sterling verzilverde kralen zijn geregen op een suk verzilverd draad en leerkoord.
1.
Large silver bead: Twist to make a double loop on the silver-plated wire. Thread the large silver bead onto the wire and then a lava bead. Now twist to make a large loop underneath the lava bead. Small silver bead(s): Twist to make double loops on the silver-plated wire on both sides of the small silver beads.
2.
Attach the leather cord to the silver part by making a decorative knot, which is tied as shown.
3.
Thread beads onto the leather cord and also thread the large pendant onto the leather cord. The silver parts are threaded onto the leather cord via the loops using the previously shown knot.
Geschreven: 23 februari 2017 door admin
Sieraden maken
Een kleurrijke ketting met mooie dot kralen en rocailles.
1
Cut five pieces of beading wire to the desired length for a chain. Close with a crimp bead and a bead tip.
2
Pull rocaille beads onto each piece of beading wire.
3
Assemble all the pieces of beading wire in a large Dot Bead.
4
Close with a bead tip and a crimp bead.
5
Attach a bead tip and a crimp bead. Squeeze the crimp bead flat, cut off the excess ends and close the bead tip. Attach a lobster claw clasp with a round jump ring.
6
For the bracelet; assemble the desired number of strings of beading wire with a crimp bead in pairs.
7
Assemble all the wires with a single crimp bead.
8
Pull rocaille beads onto the pieces of beading wire. Some need more beads than others so the bracelet does not become too stiff. Experiment with different combinations.
9
Assemble all the wires in a large Dot Bead.
10
Attach more rocaille beads onto the beading wires and finish with crimp beads, similar to the opposite end. Pull on a bead cap or an end cap.
11
Attach more beads and make a loop. Pass the beading wire back through the bead cap, tighten and squeeze the crimp bead flat. Cut off excess wire.
12
At the other end also attach a bead cap. Attach beads onto the wire and “tie knots”. Pass the beading wire through the bead cap and the crimp bead. Squeeze the crimp bead flat and cut off excess wire.
Geschreven: 23 februari 2017 door admin
Armband met wol en glas
De armband is gemaakt van wol kralen, glas link kralen, porseleinen kralen en een verzilverde bal. Alle kralen zijn geregen op kralendraad. De sluiting is een zilverkleurige cirkel sluiting.
1.
Attach an inter-locking 2-part ring clasp. Close with a crimp bead.
2.
Pull beads onto the wire. Use a darling needle for the wool beads.
3.
Close the bracelet in the same way as it was started.
Geschreven: 23 februari 2017 door admin
Stijlvolle armbanden
Lava/zilver of keramiek/zilver kralen zijn geregen op een stuk elastisch koord en worden zo prachtige armbanden. Draag ze samen of apart.
1.
Thread the beads onto a piece of elastic beading cord. Close the bracelet with five or six tight knots – preferable reef knots. Each time a knot is tightened hard, it “locks” and does not become undone.
Geschreven: 23 februari 2017 door admin
Sieraden maken
Kralen geregen op elastisch koord gedecoreerd met stardust kralen.
Geschreven: 23 februari 2017 door admin
Oordecoratie
Oorbellen gemaakt van nietstiften gebogen in de vorm van een oorbel. Bevestig een wol kraal en een prachtige kralenkap op de oorbel.
1.
Twist the head pin with round nose pliers and around a pen or similar to make an earwire.
2.
“Pre drill” the wool bead with a darning needle. Push the eye pin through. Put on the bead cap.
3.
Use the round nose pliers to twist to make a double loop.
4.
Attach the pendant to the earwire.
Geschreven: 23 februari 2017 door admin
Een “warme” armband
Rijg wollen en keramieke kralen op een stuk elastisch koord.
1.
Thread wool and ceramic beads onto a 1mm elastic beading cord. Use a darning needle with a pointy tip.
2.
Tie five or six knots on the elastic beading cord. Pull tight after each knot. This locks the knot. Preferably use reef knots.
Geschreven: 23 februari 2017 door admin
Instructions
Cut 3 pieces of elastic beading cord for 3 seperate bracelets.Tie with 4-5 tight knots.
Geschreven: 23 februari 2017 door admin
Dubbele armband van katoen
Keramiek kralen en fashion links geregen op een dubbele armband van katoen. Een zilveren vis op een nietstift met bal en bevestigd aan een ring.
1.
Undo the knot and attach a metal ring instead of the fabric ring.
2.
Pull trendy ceramic beads and fashion links onto the bracelet. “Twist” the cotton bracelet through the bead and pull it through.
3.
Put the fish onto a ball head pin and twist to form a loop.
4.
Assemble the pendant with the ring using an oval ring.
5.
Put this pendant and several more rings onto the bracelet.
6.
Gather the two fabric ends with a knot.
Geschreven: 23 februari 2017 door admin
Trendy ketting
Grote trend keramiek kralen en hangers van kristal aan elkaar gemaakt met ovale ringen en 1mm verzilverd draad. Afgewerkt met een stuk leerkoord.
1.
Assemble the ceramic heart with the crystal flower pendant using an oval jump ring.
2.
Cut a piece of silver-plated wire. Twist to form a loop and attach this to the flower before closing the loop completely.
3.
Thread the ceramic beads onto the wire. Finish with a loop (remember that the loop most turn towards the back and in the same direction as the first loop). Attach the crystal pendant to this loop before closing it completely.
4.
Insert a piece of leather cord measuring approx. 1m through the oval jump ring. Wind one end of the cord around the doubled-over cord a few times, feed the end through all the loops and pull. Tie a knot with the cord ends which will be at the back of the neck.
