Categorie: | Geen categorie

12294 Sieraden School. Ketting met sluiting

Geschreven: 23 februari 2017 door admin

Ketting met sluiting

Tigertail is ijzerdraad bedekt met een plastic coating. Dit maakt het draad flexibel en gemakkelijk om mee te werken. Sieradendraad is ook sterk en kan veel kralen dragen zonder kracht of vorm te verliezen.

Sieradendraad met veel strengen is zachter en wordt gebruikt voor delicate en lichte kralen. Terwijl sieradendraad met minder strengen ideaal is voor grote en zware kralen. Als het sieradendraad gevuld is met kralen tot de gewenste lengte, sluit af met een slot. We hebben het u gemakkelijk gemaakt door een starterset samen te stellen die een goede basis biedt om snel te starten met sieraden maken. Uiteraard kunnen de onderdelen ook los worden gekocht.

1.

Start by threading a bead tip and a crimp bead onto the wire. Squeeze the crimp bead flat.

2.

Cut off the beading wire right after the crimp bead.

3.

Close the bead tip around the crimp bead. Thread beads onto the beading wire.

4.

Use the same closing procedure at the opposite end. At this end, squeeze the crimp bead flat into the bead tip. Fill the beading with beads but do not make it too tight.

5.

Attach the clasp:

Insert a round jump ring into the loop of the bead tip and close it with two flat nose pliers. Slightly twist the ends past each other whilst they scrape against each other. Only twist to the side – never apart.

6.

When the two ends of the round jump ring are exactly opposite each other, finish twisting.

7.

Before closing the round jump ring at the other end, attach a lobster claw clasp.

8.

TIPS:
A clasp and round jump rings easily add another 2 or 3cm to the length of the necklace. Include this in the desired finished length.

9.

Variant: Individual beads on the wire. The beads are held in place with crimp beads. Squeeze the crimp bead flat with crimping pliers. Place the crimp bead and squeeze as shown on each side of the bead.

10.

Squeeze the crimp bead flat, forming a curve.

11.

Assemble the curve to make a round bead using the outer jaws on the pliers.

Comments are closed.