Dienblad met decoupage

Dienblad geverfd met Plus Color acrylverf en gedecoreerd met servetten.

1

Paint the tray, try to avoid painting the bottum.

2

Part different napkins in three and use the top part with print.

3

Tear the napkin into pieces.

4

Brush with decoupage lacquer on a small part of the tray at the time, put on the pieces of napkin and brush on top using decoupage lacquer.

5

Finally brush on more time with the decoupage lacquer.

Buitenspelen

Deze prachtige schepen zijn gevormd van kippengaas. Het geraamte is bekleed met wit krantenpapier en VTR Adhesive en tenslotte stro zijde papier. Het belangrijkst is de boten te vernissen met Paverpol, zodat ze waterbestendig worden.

De oudere kinderen van de lagere school hebben volwassenen nodig om de rompen van de boten te vormen. Het gekozen papier mag niet te dik zijn. We adviseren blanco nieuwspapier. Voeg ter decoratie gekleurd papier toe of verf de boten. Het vernissen met Paverpol is belangrijk om de boten zeewaardig te maken. Hulp van volwassenen is nodig bij het uitvoeren van deze taak, omdat Paverpol lijm moeilijk egaal te verdelen is over de boot.

Het leukste onderdeel is het te water laten van de kleine boten. Dit is een prachtige activiteit voor een warme zomerse dag.

1

Shape the hull of the boat by bending a narrow piece of wire netting. “Sew the hull together” with floral wire.

2

Cut strips of blank newspaper. Apply the pieces of newspaper layer-on-layer onto the wire netting using VTR adhesive.

3

When the hull is covered inside and outside, either paint the hull or cover it with silk paper.

4

Apply Paverpol onto the boat’s surfaces to make it water resistant. Let it dry. Now we can go sailing …

Prachtige kaart met mozaiek

Bedrukt natuurlijk papier gedecoreerd met knopen van karton en andere scrapbook versieringen, bevestigd op een blanco kaart.

1

Cut nine small squares from different types of paper.

2

Glue them onto the card with double-sided adhesive tape.

3

Attach brads in some of the squares. Use a needle to make a hole for the brads.

4

Glue chipboard buttons onto the rest of the squares.

1.

Fold a square piece of paper twice diagonally, open again and then fold it twice halfway and open again.

2.

Then fold into a square ¼ of the size of the original square. The openings are at the top.

3.

Fold the right side panel towards the middle so that the outer edge ends in the middle.

4.

Press the edges and smooth out. Do the same with the three other sides.

5.

Now fold the top two side corners towards the middle and smooth out.

6.

Do the same with the three other sides.

7.

Now unfold the underlying fold and press it down and smooth it. Repeat on all the sides.

8.

Fold the middle point, which has now appeared, upwards. Repeat on the other sides.

9.

Turn the paper so that the closed side is in front.

10.

Now fold both corner sides towards the middle, press and smooth out. Repeat with the other three.

11.

Fold down the top point revealing a small triangle of the flower.

12.

The lily can now be unfolded and you may roll the petals slightly with a pencil.

13.

A piece of silver plated wire is inserted through the hole of an alligator clip. A blob of glue is applied with a glue gun. Glue on the flower and wrap the wire around to keep it firmly in place.

See more examples